Anritsu MG3641A - Manual (Page 132)

SECTION 6 GPIB
6-26
(3) Device dependent error group
Error codes –300 to –399 indicate that a device error other than command, execution, and query errors occurred in
the device. Bit 3 in the standard event status register of the device is set at occurrence of an error.
Error code Message Error detection conditions
–310 System error A system error occurred.
–311 Save/recall memory lost The save/recall memory was lost.
–350 Self-test failed The self-diagnosis failed.
(4) Query error group
Error codes –400 to –499 indicate that a message exchange protocol error occurred in the output buffer control
unit of the device. Bit 2 in the standard event status register of the device is set at occurrence of an error.
Error code Message Error detection conditions
–410 Query INTERRUPTED An interrupt was generated by a new command
before the device sent a response message.
–420 Query UNTERMINATED No query corresponding to a response message to
be read is sent. The query does not terminate com-
pletely.
–430 Query DEADLOCKED An attempt was made to buffer a large amount of data
exceeding a storage space.