Anritsu MG3641A - Manual (Page 78)

SECTION 4 OPERATING INSTRUCTIONS
Once you have set the sweep parameters, you execute the sweep.
(7) Press the "Rtn" [F5] key in the "Sweep Parameter" menu
to return to the "Sweep" menu.
(8) Pressing the " " [F2] key starts the sweep.
(9) Pressing the "
■" [F3] key with the sweep under way
aborts the sweep.
Moreover, pressing " " key will hold the sweep
temporarily. Another press to the [F2] key will resume
the sweep.
During hold, the [F2] key is displayed as .
4.10.3 Sweep Auxiliary Outputs
While the signal generator performs sweep, it outputs signals that are synchronized to the sweep through the four
connectors located on the rear panel, as follows:
(1) X Out
Outputs sawtooth waves that are at 0 V at the sweep start point, and at +10 V at the sweep end point.
(2) Z Out
Outputs "H"-level TTL signals while it continues with sweep.
(3) Blanking Out
Outputs "H"-level TTL signals every sweep step, from the time when hardware setting is completed, till the next
step setting begins
(4) Marker Out
Outputs "H"-level TTL signals when the actual sweep matches the marker point which was set in the "Sweep
Parameter" menu.
9
8