Anritsu MG3641A - Manual (Page 185)

SECTION 9 STORAGE AND TRANSPORTATION
9-1
SECTION 9
STORAGE AND TRANSPORTATION
This section describes daily maintenance, storage, and transportation of the MG3641A/MG3642A.
9.1 Daily Servicing and Preventive Maintenance
To prevent degradation of the performance of the MG3641A/MG3642A, the MG3641A/MG3642A should be operated
correctly under the specified conditions. Calibration and performance tests should also be performed routinely.
The regular servicing method and interval are shown in Table 9-1.
Table 9-1. Regular Servicing
Period Method
Soiling
Dust
Lubrication
Loose screws
* Do not use acetone or benzene; the paint finish may be damaged.
9.2 Storage Precautions
This paragraph describes the precautions to take when storing the MG3641A/MG3642A for a long time.
9.2.1 Precautions before storage
1. Wipe any dust and fingermarks off the cabinet.
2. Check the performance to confirm that the MG3641A/MG3642A operates normally.
3. The maximum and minimum storage temperature range is 60
° to −20 °C. The maximum humidity is 90 %.
4. Avoid storing it in locations where if may be exposed to direct sunlight, condensation (more than 90 %), excessive
dust, or active gases.
Wipe with damp cloth and soapy water or
cleaning solvent if proper ventilation is
prorided.* (DAIFLON)
Open cabinet and blow out dust with
compressed air, taking care to shield face from
dust or loose particles.
Retighten with recommended tool
• Before long-term storage
• When used in dusty locations
• When noticeable dust and dirt have
accumulated inside cabinet
None
When detected