Teledex I Series - Manual (Page 10)

10 www.teledex.com I SERIES ANALOG USER GUIDE
Unpacking Your Telephone
This package should contain the following:
• Handset
• Line cord
• Phone base unit
• Clear plastic overlay
• Coiled handset cord
• User guide
Installation
CAUTION INFORMATION
• Never install telephone or network wiring
during a lightning storm.
• Never install telephone or Ethernet jacks in
wet locations unless the jack is specifically
designed for wet locations.
• Never touch uninstalled telephone wires or
terminals unless the telephone line has been
disconnected at the network interface.
• Use caution when installing or modifying
telephone and network lines.
CONNECTING THE I SERIES A SERIES
1. Located on the left side of the I Series
phone (as the phone is facing you) is a
modular jack. Insert one end of the coiled
handset cord into this jack (you should hear
the coil cord click when properly inserted).
2. Insert the other end of the coiled handset
cord into the modular jack on the handset.
3. Turn the telephone so the back panel
is facing you. Insert either end of the
line cord into the jack on the back of the
telephone labeled LINE.
4. Insert the other end of the line cord into a
telephone wall outlet jack.
5. Once your telephone is connected, remove
the plastic overlay and place the paper
faceplate over the keys. Replace the plastic
overlay by hooking the tabs on the overlay
into the recessed slots located on both sides.
CONVERTING FROM DESK TO WALL
MOUNT
The I Series phone can be converted for wall
mounting applications. The conversion is easiest
when the handset and line cords are not connected.
1. Located on the top of the telephone above
the speaker grill is the wall/desk mount
clip. Remove this clip by firmly pushing
upward (towards the hookswitch).
2. Flip the clip over (top to bottom) so that
the protruding edge is towards the top of
the phone, and reinsert into cutout. This
protruding edge will hold the handset.
3. Turn the telephone over so the bottom is
up, facing you. Place the telephone on a
non-abrasive surface to prevent scratching.
4. Locate and remove the mounting bracket,
firmly push back and pull up to remove two
of the four retaining tabs.
5. Rotate the mounting bracket 180 degrees
clockwise so that the mounting eyelet on
the bracket is facing in the same direction
as the other mounting eyelet located on
the bottom of the telephone.
6. Insert the top two retaining tabs of the
mounting brackets into the mounting
bracket slots (located near the middle of
the telephone). Then firmly push down to
insert the retaining tabs on the opposite
side of the mounting bracket.
7. Connect a short modular line cord into
the jack on the back of the phone (labeled
LINE). Route the line cord through the
line cord channel. Connect the other end
of line cord to the phone jack on the wall
mounting plate.
8. Turn the telephone over, and slide the
telephone down onto the mounting posts
in downward direction. Both eyelets should
line up with the mounting posts.
9. Complete the wall mounting by installing
the handset and handset cord.
I SERIES A SERIES PHONES (ANALOG CORDED)