Teledex I Series - Manual (Page 18)

18 www.teledex.com I SERIES ANALOG USER GUIDE
call entirely, press either the CONF key or SPKR
key to disconnect both parties.
Programming
AUTO DIAL KEYS
The AC Series has either five (5) or ten (10)
programmable guest service (auto dial) keys,
depending on the model you own. These keys
can be programmed to automatically dial
telephone numbers, or to activate telephone
system features. To program the auto dial keys
(programming can only be done from base unit):
1. With the phone on hook (inactive) and the
faceplate removed, press the recessed
STORE key (see diagram).
2. Enter the desired telephone number (up to
15 digits in length) to be stored. To enter
a “pause” in the number string, press the
REDIAL key as necessary.
3. Press the STORE key again.
4. Press the auto dial key where the number
is to be stored. Programming is now
complete for that auto dial key. To program
additional keys, repeat this process.
PAUSE KEY
The PAUSE key can be used to provide a timed
pause between dialed digits within a stored
auto dial number. The timing of the pause is
programmable, with the factory default set to
one (1) second. To change the pause timing:
1. With the phone on hook (inactive) and the
faceplate removed, press the recessed
STORE key (see diagram).
2. Press the STORE key (see diagram on
inside front cover for key location).
3. Press an number from 0 to 5 on the
dialpad. The number selected will be the
pause timing in seconds (for example:
pressing the 3 key will insert a 3-second
pause, etc.).
4. Press the PAUSE key (see diagram for key
location).
5. Press the STORE key. The selected pause
is now inserted into the dialing string.
FLASH KEY
The FLASH key, when programmed behind an
auto dial key, provides a timed line interrupt
typically used for accessing PBX/CO features
such as transfer or conference. The timing of
the hookflash is programmable, with the factory
default set to 600 milliseconds. Some PBXs may
require you to change the hookflash timing from
this default. To change the hookflash timing:
1. With the phone on hook (inactive) and the
faceplate removed, press the recessed
STORE key (see diagram).
2. Press the STORE key (see diagram on
inside front cover for key location).
3. Select 1–9 on the DTMF pad. The number
selected will be the new flash timing in
hundreds of milliseconds (i.e., pressing the
3 key will reset the flash to 300 ms, etc.).
4. Press the FLASH key (see diagram for key
location).
5. Press the STORE key. The selected flash
timing is now programmed.
MESSAGE
Pressing the touch bar automatically turns on
the speakerphone and then dials into a user-
programmed voice mail system to retrieve
messages.
I SERIES AC SERIES PHONES (ANALOG CORDLESS)