Teledex I Series - Manual (Page 11)

I SERIES ANALOG USER GUIDE www.teledex.com 11
I SERIES A SERIES PHONES (ANALOG CORDED)
Operation
VOLUME CONTROL
ADJUSTING THE HANDSET VOLUME
To the left of the dialpad, locate the volume up/
down arrow keys. While using the handset,
either during an active call, or preparing to dial,
press either the up or down key to raise or lower
handset volume to the desired level.
ADJUSTING THE RING VOLUME
On the rear panel of the telephone, locate
the ringer volume slide swtich. There are two
settings: Low and High. Set the switch to the
desired setting.
ADJUSTING THE SPEAKERPHONE VOLUME
To the left of the dialpad, locate the volume up/
down arrow keys. With the speakerphone active,
press either the up or down key to raise or lower
speaker volume to the desired level.
INDICATORS
SPEAKER, MUTE, AND HOLD KEY
CONNECTING AND STATUS INDICATORS
Speakerphones are equipped with LED indicators
to show the current feature key status.
• Press the Speaker, Mute, or Hold feature key
to use that service—the LED will light red
when that key is IN USE.
CALLING
PLACING A CALL USING THE HANDSET
1. Lift the handset. The LINE LED will
illuminate. (On two-line models, if both
lines are inactive, Line 1 will be activated.
If one of the two lines is active, the inactive
line will be activated.)
2. Listen for dial tone. Dial the desired
number, or press an AUTO DIAL key to
automatically dial a number.
3. To end the call, hang up by placing the
handset back in the cradle.
PLACING A CALL USING THE SPEAKERPHONE
(ONLY MODELS WITH SPEAKERPHONE)
1. With the handset in the cradle, press
either the SPEAKER key or the LINE key
(on two-line models, select either inactive
LINE key). The telephone will go offhook
on the selected line with speakerphone
active.
2. Listen for dial tone, and dial the desired
number, or press an AUTO DIAL key to
automatically dial a number.
3. To end the call, press the SPEAKER key.
RECEIVING A CALL
TO ANSWER A CALL USING THE HANDSET
1. Lift the handset. On two-line models, if one
line is already in use, the I Series phone
will automatically select the ringing line.
2. To end the call hang up the handset.
TO ANSWER A CALL USING THE
SPEAKERPHONE
1. With the handset in the cradle, press the
line key associated with the ringing line.
The I Series phone will answer the line selected
with the speakerphone active. You may also:
2. Press the SPEAKER key. The I Series
phone will select the ringing line and
answer with the speakerphone active.
Note: The red SPEAKER LED will indicate that
the speakerphone is active.
USING THE SPEAKERPHONE
(SPEAKERPHONE-EQUIPPED MODELS)
If you are talking on the handset and wish
to transfer to the speakerphone, press the
SPEAKER/HSET key, and hang up the handset in
the cradle. The speakerphone will now be active.