Teledex I Series - Manual (Page 17)

I SERIES ANALOG USER GUIDE www.teledex.com 17
I SERIES AC SERIES PHONES (ANALOG CORDLESS)
SELECTING LINE 1 AND LINE 2
(TWO-LINE MODELS ONLY)
The AC Series employs PrimeLine/RingLine
Select, so selecting the correct line is as easy as
lifting the handset. This feature prioritizes the
ringing or idle line and reduces the confusion of
line selection. You may also manually select the
desired line by pressing either Line 1 or Line 2
keys.
REDIAL
The AC Series can automatically redial the last
number dialed. On either the handset or base,
press the REDIAL key to redial the last number.
USING THE HOLD KEY
The HOLD key places the call on hold locally at
the cordless telephone.
TO PLACE A CALL ON HOLD
1. With a call active, press the red HOLD key
on either the handset or base unit.
2. The red line LED will slowly blink,
indicating the call is on hold.
TO REMOVE A CALL FROM HOLD
1. Press the line key of the call on hold, or
the HOLD key again. This will remove
the call from hold, making the call active
again.
2. The red line LED will return to steady
illumination, indicating the line is active.
TO CHANGE PHONES AFTER PLACING A CALL
ON HOLD
1. Place the call on hold as above.
2. Pick up the call at another telephone that
is on the same line. The telephone will
activate the line and remove the hold at
the original telephone.
TO MUTE THE SPEAKERPHONE
1. Press the MUTE key on the base unit.
The red LED above the MUTE key will
illuminate. The party on the other end will
not be able to hear you when the MUTE
LED is lit.
2. Press the MUTE key again to turn off the
mute feature. The MUTE LED will go out.
CONFERENCE (TWO-LINE MODELS
ONLY)
The CONF key allows for three-way conversations.
Depending on the situation, you may initiate a
conference call using one of these methods:
USER INITIATES TWO CALLS
1. Place call to first party, then place them on
hold by pressing the HOLD key.
2. Using the second line, place call to second
party.
3. Once that party is on the line, press CONF
to join all three parties.
USER INITIATES ONE CALL
1. After receiving a call from first party, place
them on hold by pressing the HOLD key.
2. Using the second line, place call to the
second party.
3. Once that party is on the line, press CONF
to join all three parties.
USER INCLUDES TWO PARTIES
1. After receiving a call from first party, place
them on hold by pressing the HOLD key.
2. After receiving call from second party,
press CONF to join all three parties.
To terminate a conference call, pressing a line
key will maintain the connection with that line,
while dropping the other line. To terminate the