Teledex I Series - Manual (Page 16)

16 www.teledex.com I SERIES ANALOG USER GUIDE
I SERIES AC SERIES PHONES (ANALOG CORDLESS)
Notice: The Ringer Equivalence Number (REN)
assigned to each terminal device provides an
indication of the maximum number of terminals
allowed to be connected to a telephone interface.
The termination on an interface may consist of
any combination of devices subject only to the
requirement that the sum of the Ringer Equivalence
Numbers of all the devices does not exceed 5. This
telephone connects to the telephone network
under the connecting arrangement code CA11A.
Operation
ADJUSTING SPEAKERPHONE VOLUME
The speakerphone has eight (8) levels. To adjust
speakerphone volume, locate the volume up/
down keys, located on the front of the phone to the
left of the keypad. With the speaker active, press
the “down” arrow key to decrease the volume
level, and press the “up” arrow key to increase it.
ADJUSTING HANDSET RECEIVE
VOLUME
The handset has eight (8) volume levels. To adjust
the handset volume, locate the volume up/down
keys, located on the handset, below the “#” key.
Pressing the UP arrow key will decrease the
volume level, while pressing the DOWN arrow key
will increase it.
RECEIVING A CALL
An audible ring and flickering red LED indicate an
incoming call.
TO ANSWER A CALL USING THE HANDSET
WHILE IT IS NOT ON THE BASE
1. Pick up the handset.
2. Press the line key. The handset will go
“off-hook” answering the phone.
3. To end the call, place the handset in the
base unit cradle or press the OFF key on
the handset.
TO ANSWER A CALL USING THE HANDSET
WHILE IT IS RESTING ON THE BASE
1. Pick up the handset from the base.
2. To end the call, replace the handset in the
base unit cradle, or press the ON key on
the handset.
TO ANSWER A CALL USING THE
SPEAKERPHONE
1. Press the line key. The speakerphone will
go “off-hook”, answering the ringing line.
2. Alternatively, press the SPKR key.
3. To end the call, press the SPKR key or the
line key again.
PLACING A CALL
USING THE HANDSET
1. Pick up the handset and select either Line
1 or Line 2. Listen for dial tone and dial the
desired number, or press an auto dial key
to dial a preprogrammed number.
2. After the call is complete, press the key for
the selected line again to end the call.
USING THE SPEAKERPHONE
1. Press a key for either Line 1 or Line 2, or
press SPKR.
2. Listen for dial tone, and dial the desired
number, or press an auto dial key to dial a
preprogrammed number.
3. After the call is complete, press the SPKR
key to end call.