Teledex Opal Series - Manual (Page 15)

OPAL SERIES USER GUIDE www.teledex.com 15
OPAL SERIES 1-LINE CORDLESS AND REDIDOCK PHONES
3. For some PBX systems that provide
reverse polarity message signaling, it may
be necessary to move the switch to either
LR1 or LR2. The correct position of the
switch will cause the message lamp to be
on continuously when a message is in the
mailbox.
PAGE
CALL THE HANDSET
Press the base unit’s Page key to call the handset,
and the handset’s message and On/Off indicator
lights flash. Press the Page key again or any
key in the handset or place the handset into the
cradle to end the page.
REGISTERING A HANDSET
Auto-Sync Handset Registration
Pairing the handset to the base is an easy process
that should need to be performed only once. After
installing the battery, and securing the cover with
the 2 screws provided, place the handset into
the base unit cradle and make sure the charging
leads make contact. The Registration process
may take as long as 1 minute to complete, as
the handset and base station exchange large
amounts of encoded data. When the base and the
handset have successfully paired, the phone will
beep a Registration confirmation tone.
Each handset can sync with only ONE base
station at a time. When a handset gets moved
to a different base station, it will immediately
sync with the new base station. After this the
handset is no longer synced with its original base
station, which means that if a cordless handset is
accidentally moved into a different room, then the
handset will wind up synced with the base station
in the new room.
SWITCH BETWEEN BASE AND HANDSET
If the handset is registered with the base unit then
the handset and base can switch the call freely.
To switch from the handset to the base, press the
Speaker key in the base unit and then press the
On/Off key in the handset to switch from base to
handset.
SWITCH BETWEEN HANDSETS
Every base unit can register up to 4 additional
handsets. If one of the handsets is picking up
a call, any one of the other handsets can pick
up the call by pressing the On/Off key. The On/
Off indicator of the other handsets will flash to
display that the phone is in use.
Programming
PROGRAM SPEED-DIALS USING
SUBMERGED [STORE] AND [FLASH]
[Store] and [Flash] programming keys are located
under the faceplate and overlay. Begin by lifting
up faceplate and overlay using either a paperclip
or sharp pointer.
STORING A NUMBER INTO MEMORY
KEYS—[STORE]
Each speed-dial location can store up to 24 digits
in tone mode.
Note: Flash programmed into memory counts as
one digit when storing a number.
1. Leave handset in cradle/on-hook.
2. Press the STORE key.
3. Enter the number to be stored using the
numeric dial pad.
4. Press STORE key.
5. Press the desired memory location where
the number is to be stored.
6. If additional numbers are to be stored,
repeat steps 2 through 5.