Teledex Opal Series - Manual (Page 19)

OPAL SERIES USER GUIDE www.teledex.com 19
CASE A—USER INITIATES TWO CALLS
1. Place your call to the first party, then put
them on hold by pressing the Hold key.
2. Using the second line (Line 2), place your
call to the second party, then place them
on hold by pressing the
Hold key.
3. Activate the conference by joining the calls
together when you press the Conf key.
CASE B—USER RECEIVES A CALL AND
PLACES A SECOND CALL
1. Receive a call from the first party then put
them on hold by pressing the Hold key.
2. Using the second line (Line 2), place call to
second party, then place them on hold by
pressing the
Hold key.
3. Activate the conference joining the calls
together by pressing the Conf key.
CASE C—USER RECEIVES A CALL AND THEN
RECEIVES A SECOND CALL
1. Receive the call from the first party and
put them on hold by pressing the Hold key.
2. Using the second line (Line 2), place your
call to the second party, then put them on
hold by pressing the
Hold key.
3. Activate the conference call by pressing
the Conf key which will join the calls
together.
Programming
PROGRAM SPEED DIALS USING
SUBMERGED [STORE] AND [FLASH]
Store and Flash programming keys are located
under the faceplate and overlay. Lift up faceplate
and overlay by using either a paperclip or sharp
pointer.
STORING A NUMBER INTO MEMORY
KEYS—[STORE]
Each speed-dial location can store up to 32 digits
in tone mode.
Note: Flash programmed into memory counts as
one digit when storing a number.
1. Lift the handset.
2. Press the STORE key.
3. Enter the number to be stored using the
numeric dial pad.
4. Press the desired memory location
wherein the number is to be stored.
5. If additional numbers are to be stored,
repeat steps 3 through 5.
6. Hang up the handset.
PROGRAMMING FLASH TIMING
Flash timing options are 100 ms through 1000
ms, programmable in 100 ms increments. The
default Flash timing is 600 ms.
1. Lift the handset (off-hook position).
2. Press the STORE key once.
3. Program FLASH by pressing 1 for 100 ms,
2 for 200 ms, etc.
4. Press STORE.
5. Press FLASH.
6. Exit programming by hanging up the
handset.
PROGRAMMING PAUSE TIMING
Pause timing options are 1 second through 5
seconds, programmable in 1 second increments.
The default pause timing is 3.5 seconds.
1. Lift the handset (off-hook position).
2. Press the STORE key once.
3. Program PAUSE by pressing 1 for 1
second, 2 for 2 seconds, etc.
OPAL SERIES 2-LINE CORDED AND TRIMLINE PHONES