Teledex B-Series - Manual (Page 46)

1. FEATURES
The Teledex B220 is a two-line telephone with a high-performance speakerphone
and ten one-touch programmable feature buttons. The memory for these buttons is
stored in a non-volatile EEPROM, and does not require a battery backup.
Your B220 has these useful features:
1.1 AUTO LINE SELECTION – Automatically selects the available, idle line
using either the handset or the speakerphone.
1.2 AUTO RINGER SELECTION – Automatically selects the ringing line
using either the handset or the speakerphone.
1.3 3-WAY CALL CONFERENCING – For easy three-way conversations
1.4
SPEAKERPHONE – For convenient hands-free conversations.
1.5 RINGER CADENCE ADJUSTMENT – provides selection of unique
ringing cadences for each line.
1.6 TEN (10) ONE-TOUCH MEMORY LOCATIONS – For quick access to
frequently-dialed numbers or PBX/Centrex services and features.
1.7 FLASH – Sends an electronic hook-switch signal for use with special
services such as call waiting, etc.
1.8 LAST NUMBER REDIAL – Dials the last number dialed.
1.9 HOLD – Places a call on hold.
1.10 MUTE – Mutes the microphone of the handset or speakerphone.
1.11 RELEASE – To re-access dial tone without depressing hook switch
1.12 VOLUME CONTROL – Adjusts volume of handset or
speakerphone.
1.13 DATA PORT – Enables parallel connection of another telephone, fax or
answering machine, or laptop computer to the phone line.
1.14 HEARING AID COMPATIBLE
The B220 is ETL listed to UL standards and meets all applicable FCC standards and
requirements.
2. UNPACKING YOUR B220
Inside the box, you will find all of the items needed for installation, as shown below:
Check to be sure that your package includes all the above items. If any items are
missing or damaged, please contact the distributor where you purchased the phone.
3. INSTALLATION
3.1 DESKTOP INSTALLATION
1) Plug one end of the handset coiled cord into the handset. Plug the other
end of the cord into the handset jack located on the left side of the phone
base. (Refer to figure 3.)
2) Place the handset in the handset cradle.
3) Plug one end of the supplied line cord into the LINE jack on the bottom of
your phone. Then route the line cord through the left slot of the desk/wall
mount bracket.
4) Plug the other end of the modular cord into the wall jack.
3.2 WALL MOUNTING
1) Plug one end of the handset coiled cord into the handset. Plug the other
end of the cord into the handset jack located on the left side of the phone
base (please refer to figure 3.)
2) Place the handset in the handset cradle.
3) Remove the desk/wall mount bracket from the bottom of the B220. Rotate
the bracket 180º and re-install it into the four slots the bottom of the B220.
4) Connect the short line cord into the LINE jack on the bottom of your
phone. Connect the other end of the line cord to the line jack on the wall
mount plate.
5) Slip the phone onto the wall plate jack, lining up the wall mounting holes,
and then slide the telephone down so it is firmly in place.
2 3
FIGURE 3
FIGURE 4
FIGURE 2