Teledex B-Series - Manual (Page 66)

30) REQUIREMENTS OF PART 68- FCC RULES
This device has been granted a registration number by the Federal Communications Commission, under
Part 68 rules and regulations for direct connection to the telephone lines. In order to comply with these
FCC rules, the following instructions must be carefully read and applicable portions followed completely:
1) Direct connection to the telephone lines may be made only through the standard modular cord fur-
nished, to the utility installed jack. No connection may be made to party or coin phone lines. On the bottom
of the phone is a label that contains among other information, the FCC Registration Number and the
Ringer Equivalence number (REN) for this equipment. If requested, this information must be provided to
the telephone company. The USOC jack for this equipment is RJIIC.
2) The telephone company may, under certain circumstances, temporarily discontinue and make changes
in facilities and services which may affect the operation of the users’ equipment; however, the user shall be
given adequate notice in writing to allow the user to maintain uninterrupted service.
3) In certain circumstances, it may be necessary for the telephone company to request information from
you concerning the equipment which you have connected to your telephone line. Upon request of the tele-
phone company, provide the FCC registration number and the ringer equivalence number of the equipment
which is connected to your line. This information will be found on the bottom of your telephone.
4) If any of your telephone equipment is not operating properly, you should immediately remove it from the
telephone line. It may cause harm to the telephone network.
5) If the telephone company notes a problem, they may temporarily discontinue service. When practical,
they will notify you in advance of disconnection. If advance notice is not feasible, the telephone company
must: Promptly notify you of such temporary discontinuance; Afford the opportunity to correct the condition;
Inform you of your rights to bring a complaint to the FCC under their rules.
6) Repairs to the device may be made only by the manufacturer or an authorized service agency. This
applies at any time during and after warranty. If unauthorized repair is performed, registration, connection
to the telephone lines and remainder of warranty period all become null and void.
7) This equipment is hearing aid compatible.
8) This telephone must be connected behind a PBX.
31) REQUIREMENTS OF PART 15- FCC RULES
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instruction, may cause harmful inter-
ference to radio communications. However, there is not a guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: 1) Move the telephone away from the receiver. 2)
Consult the dealer or an experienced radio/TV technician for help. Any changes made by the user not
approved by the manufacturer can void the user’s authority to operate the telephone.
32) INDUSTRY OF CANADA REQUIREMENTS
NOTICE: The Industry Canada label identifies certified equipment. This certification means that the equip-
ment meets certain telecommunications network protective operational and safety requirements as pre-
scribed in the appropriate Terminal Equipment Technical Requirements documents. The department does
not guarantee the equipment will operate to the user satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities
of the local telecommunications company. The equipment must also be installed using an acceptable
method of connection.
15
Teledex B250D Users Manual
NOTICES AND REQUIREMENTS
Contents Copyright © 2003 Teledex LLC