MagTek IntelliStripe 60 99875135 - Manual (Page 13)

5
SECTION 2. INSTALLATION
The Installation of the IntelliStripe 60 Insertion Reader includes mechanical and electrical
connections.
MECHANICAL MOUNTING
Mounting options for the Reader are as follows:
• Front Flanges only
• Side Mounting Studs only
• Side Mounting Holes only
• Front Flanges and Side Mounting Studs together
• Optional standoffs for chassis or secondary PCB mounting
Chassis mounting features are shown in Figure 2-1. Standoff mounting is shown in Figure 2-2.
Mounting dimensions are shown in Figure 2-3. Descriptions of the mounting options are as
follows:
Front Flange
Two molded mounting flanges toward the front of the chassis provide slots for attachments. (See
Figures 2-1 and 2-3.)
Side Mounting Studs
There are four molded studs. Two are located on each side of the chassis. Optional threaded
inserts can be inserted in both ends of the studs with either imperial or metric sizes. (See Figures
2-1 and 2-3.)
Side Mounting Holes
Four molded holes are available when studs are not provided. Holes are positioned inline with
the center line of the stud with molded nut retaining features. (See Figures 2-1 and 2-3.)
Stand-offs
Threaded stand-offs located on the upper side of the Reader are optional. Standoffs may be used
for chassis or third party PCB mounting. (See Figure 2-2.)
I/O Connectors
The IntelliStripe 60 contains a fixed 26-pin I/O connector, which connects to the user's circuit.
The Host manipulates and monitors the signals on the 26-pin header and implements the
following functions:
• Enable/Disable and monitor status of TK 1, 2, 3 Mag-stripe read operations
• Smartcard read-write operations
• Monitors status of Card Present switch, Card Seated switch, and Card Latched switch
(external pull-up resistors are required)
• Control of Card Latch mechanism