MagTek IntelliStripe 60 99875135 - Manual (Page 31)

Appendix B. Bezel Configuration and Mounting
23
INTERNATIONAL METAL BEZEL MOUNTING
The International Metal Bezel (P/N 21161204) is shown and described in Figure B-3. The Bezel
also requires the front flanges for attaching the Bezel to the unit (see Figure B-1). Four screws
are inserted into the front flange slots to retain the unit to the Bezel. These screws are thread
cutting and may be either Phillips head or T10 Torx
P
®
P
.
Figure B-3 also shows the orientation and dimensions of the Bezel and recommended
dimensions for the panel opening. Four screws that mount the Bezel to the panel are also M3.5.
The length of the screws depends on the panel thickness, washers, and spacers used in mounting
the panel.
Compatibility
The Metal Bezel is not compatible with some units. The units compatible with the Metal Bezel
are 1) front mount and 2) front and side mount together (M1 and M3). The units not compatible
with the Metal Bezel are 1) side mount and 2) no mount (M2 and M4). Table B1 lists examples
of units compatible with the Metal Bezel. Table B2 lists examples of units not compatible with
the Metal Bezel.
Table B-1. Examples of Configurations Compatible with the Metal Bezel
Part Number Model or Chassis Mounting Options Description
21161130 Chassis M1 – Front Mounted With flanges only
21161129 Chassis M3 – Front and Side Mounted With flanges and bosses
21160058 IntelliStripe 60 M3 – Front and Side Mounted With flanges and bosses
21165048 IntelliStripe 65 M3 – Front and Side Mounted With flanges and bosses
Table B-2. Examples of Configurations Not Compatible with the Metal Bezel
Part Number Model or Chassis Mounting Options Description
21161131 Chassis M2 – Side Mounted With bosses only
21161132 Chassis M4 – No Mount No flanges/bosses
21165042 IntelliStripe 65 M2 – Side Mounted With bosses only