MagTek IntelliStripe 60 99875135 - Manual (Page 34)

IntelliStripe 60, TTL Insertion Reader
26
Table C-1. Component and Connector Descriptions
Designation Description Manufacturer and P/N
J1 Connector, Latch Motor, 3 pin Molex 53048-0310
J2 Connector, Power Fail Latch
Release Capacitor, 2 pin Molex 51021-0200 Receptacle, Mates
with Molex 52048-0210 Header. Pin 1
must connect to positive side of capacitor.
J5 Connector, Secondary Head,
7pin Molex 53048-0710. Mates with Molex
51021-0700
J9 Connector, Primary Head
(facing opposite side of
Smartcard contacts), 7 pin Molex 53048-0710. Mates with Molex
51021-0700
J12 Connector, I/O, 26 pin Molex 87049-2616. Mates with Receptacle
87381-2612
J13 Connector, Smartcard Contact,
10 pin Molex 52207-1085*. Mates with MagTek
Cable, Flex Circuit, 8 contacts (P/N
21161128), or MagTek Cable, Flex Circuit,
16 Contacts (P/N 21161122)
MH Mounting Holes (4 places)
PL Pin-hole Locations (2 places)
S1 Switch, Card Present
(Mechanical) Cherry DG23-C3LA, Soldered to Board
S2 Switch, Card Seated
(Mechanical) Cherry DG23-C2LA, Soldered to Board
S3 Switch, Card Latch Sensor
(Mechanical) Cherry DG23-C3LA, Soldered to Board
* To insert flex cable, use a small screw driver to pull the locking tab out (on ear at each end of
the tab). Then insert the cable (Chrome side up), and push locking tab in.