MagTek MAXI MICR RS232 - Manual (Page 11)

3
SECTION 2. INSTALLATION
The installation for the MICR Reader is as follows:
REQUIREMENTS
The following is required for the Installation:
•
MAXI MICR RS232 With Optional 2-Track MSR (interface cable included – DB25 female
connector to PC).
•
AC Power Adapter with Cable, 120VAC to 12 VAC, 1 Amp, Part Number 64300050
PROCEDURE
Perform the following steps:
1.
On the interface cable connect the DB25 connector to the PC. If the adapter cable is
required for a DB9 serial port, connect the adapter cable to the DB25 and the DB9 to the
PC. The pin lists for these connectors are shown in Appendix E.
2.
On the AC power adapter, connect the jack to the plug on the MICR Reader.
3.
On the AC power adapter, connect the plug to the wall outlet.
4.
The LED indicator on the MICR Reader should turn on to a steady green. The LED
indicator is located below the slot where the check is first inserted for reading.
Caution
Do not place the MICR Reader within 6 inches of a computer
monitor or power supply. These devices may cause undesirable
interference with the check reading operation.