Horner APG XL7 OCS - Manual (Page 57)

XL7 User Manual
View Protocols
The View Protocols Sub-Menu displays two System Settings, neither of which may be edited.
As mentioned in
0
, both the MJ1/MJ2 (Port 1) and MJ3 (Port 2) serial ports support downloadable
protocols. To assign a downloadable protocol to an XL7 OCS serial port, select the Protocol Config item
in Cscape’s Program menu and then set up a protocol for Port 1 or Port 2 (or both).
In the View Protocols Sub-Menu, the currently downloaded protocol, if any, and its version number are
displayed for each of MJ1, MJ2 COM board and MJ3.
Set Fkeys Mode
The Set Fkeys Sub-Menu displays two System Settings, both of which may be edited.
Fkeys
Momentary= %K1-5 bits go On & Off as F1-F5 are pressed & released
Toggle= %K1-5 bits toggle each time F1-F4 are pressed
SYS_Fn enable
Yes = Reset and all clear system functions enabled
No = Reset and all clear system functions disabled
Page 57 of 110