AT&T 2455 - Manual (Page 27)

ANSWERING SYSTEM OPERATION
AT THE BASE
25
Answering System Feature Setup
You can set up one feature at a time, or you can set up a feature and then
move on to set up another feature.
1 Make sure the answering system is on.
2 Press and release
U until you hear the system announce the
feature you want to set. Refer to the “Feature Summary” below for a
description of the features and your choices.
3 Press
S to hear the feature’s settings.
4 Press
t to confirm your selection.
Feature Summary
Asterisk ( * ) indicates default settings.
System announces: Description/directions:
“Set Outgoing Message” See “Record Your Announcement” on
page 24.
“Set Security Code” Set the remote access code you will use
19 * to access features and functions of the
answering system from a touch tone phone.
“Set Day and Time” Set the clock: After you set the day, repeat
Steps 2 and 3 in “Answering System
Feature Setup” to set hours and minutes.
“Set Audible Message Alert” When Message Alert is turned on, the base
Off * beeps once every 10 seconds when new
On messages have been received.
“Set Announce Only” When you set the system to Announce
Off * Only, callers hear your announcement,
On but cannot leave a message.
“Set Base Ringer” Turn the base ringer on or off.
On *
Off
“Set Number of Rings” Choose how many times the phone will
2 ring before the system answers a call.
4 * With Toll Saver active,the system answers
6 after two rings when you have new
Toll Saver messages and after four rings when you
have no new messages.
NOTE: Exit Feature Setup at any time by pressing a MAILBOX button.