Campbell Scientific EasyAG Probe for Soil Volumetric Water Content Profiles User Manual
Page 35
Advertising
Appendix B. Tube Installation
Remove the EasyAG
TM
dolly, thread a Fair Rite
TM
bead onto a loop in the
cable but do not tighten it into place yet (refer to final installation photo for
this).
Push the cable through the cable gland and attach the wiring according to the
diagram in Section 4.
Step 5 - Inserting the Electronics
Reinstall the sensor circuitry and attach the connector or attach wiring as
required. Tighten the cable gland and seal around the inside threaded section
with silicone glue.
Step 6 – Fitting the Top Cap Lid
Replace the lid of the top cap. Tighten the screws completely to ensure an
effective seal.
B-11
Advertising