Campbell Scientific NL240 Wireless Network Link Interface - Manual (Page 25)

NL240 Wireless Network Link Interface
• Type edit and press Enter to edit the settings of the NL240.
• As each NL240 setting is shown, press Enter to accept the current value
shown in parenthesis. Type a new value and press Enter to change the
value.
• After progressing through all of the NL240 settings, type save to accept
the changes or cancel to discard the changes.
• Type bye to exit Telnet.
7.4 Configuring the NL240 via RS-232
Accessing the configuration terminal menu via RS-232 requires
the NL240 to be power cycled, so physical access to the device
will be required. A null modem serial cable will be needed; one
is not provided with the NL240.
• Using a null modem serial cable, connect your computer’s serial port to
the port labeled “RS-232” on the NL240.
• Connect to the NL240 using a terminal emulator. DevConfig’s “unknown”
device type or HyperTerminal are examples of simple terminal emulators.
The default settings for this interface are 115200 baud, 8 stop bits, no
parity, 1 stop bit, no flow control.
• Power cycle the NL240 and repeatedly press Enter at the terminal.
• Type help to see a list of the functionality available when connected to the
NL240 through Telnet.
• Type edit and press Enter to edit the settings of the NL240.
• As each NL240 setting is shown, press Enter to accept the current value
shown in parenthesis. Type a new value and press Enter to change the
value.
• After progressing through all of the NL240 settings, type save to accept
the changes or cancel to discard the changes.
• Disconnect your computer and power cycle the NL240.
8. Operation
This section describes how to configure the Wi-Fi connection and operational
mode of your NL240. See Section 6, Wi-Fi, for more information about the
types of Wi-Fi connections available. See Section 4, Overview, for help in
determining which operational mode to use.
NOTE
15