Campbell Scientific RTMC Pro Real-Time Monitor and Control Professional Software - Manual (Page 39)

RTMC Pro
Server Address
This is the hostname or TCP/IP address of the computer running the
communications server. This must be the valid name of an existing
computer or a TCP/IP address in the form XXX.XXX.XXX.XXX for an
IPv4 address or [XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX]
for an IPv6 address. If the software server resides on the same computer
as RTMC, you can simply type in LocalHost for the server address. By
default, LoggerNet’s port number is 6789. If this default port number is
used, it does not need to be specified in RTMC Pro. Otherwise, it is
specified after Server Address, separated by a colon. An example would
be 192.168.4.32:3000, where 3000 is LoggerNet’s port number. Note that
a remote LoggerNet server must have Remote Connection enabled (Tools |
Options | Allow Remote Connections) for RTMC Pro to be able to display
the remote data.
Username
Your username on the communications server.
Password
Your password for the communications server.
The Username and Password fields are required only if your
server administrator has enabled security on your system. You
can save the login information by selecting the Remember
username and password check box.
When running RTMC from RTDAQ, the server connection is
always to LocalHost. You cannot change the server address.
If LoggerNet Security is enabled and your project will be
published to the Web using CSI Web Server, you must select the
Remember username and password checkbox. You will not
be prompted for the LoggerNet Security password when viewing
your project from the web. Therefore, if the username and
password have not been saved with the project, you will not be
able to perform any functions that require the username and
password.
2.5.2 File Data Source
To add a data file press the Add button and select Add File Data Source. A
dialog box will open requiring you to specify the following:
Source Name
Designates the name that will be used for the data file in the Data Source
Browser. By default, the filename is used.
NOTE
NOTE
NOTE
33