ADTRAN TRACER 5045 - Manual (Page 34)

Section 4 Network Turnup Procedure TRACER 5045 System Manual
34 © 2004 ADTRAN, Inc. 612805045L1-1B
1. INTRODUCTION
This section discusses TRACER 5045 system installation.
2. TOOLS REQUIRED
The tools required for TRACER 5045 installation are:
• VT100 terminal or PC with terminal emulation software
• RS-232 (DB-25 male for TRACER 5045) cable for connecting to terminal
3. UNPACK AND INSPECT THE SYSTEM
Each TRACER 5045 is shipped in its own cardboard shipping carton. Open each carton carefully and
avoid deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in
transit, immediately file a claim with the carrier; then contact ADTRAN Customer Service (see Customer
Service, Product Support Information, and Training information in the front of this manual).
Contents of ADTRAN Shipment
Your ADTRAN shipment includes the following items:
• TRACER 5045 Unit
• TRACER 5045 Documentation CD
Changes or modifications not expressly approved by ADTRAN could void the user’s
authority to operate the equipment.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
This system MUST be installed by qualified service personnel in a Restricted Access
Location.