ADTRAN TRACER 5045 - Manual (Page 46)

Section 5 User Interface Guide TRACER 5045 System Manual
46 © 2004 ADTRAN, Inc. 612805045L1-1B
>TRACER S YSTEM C ONFIGURATION > S ITE N AME
Provides a user-defined alphanumeric description (up to 25 characters) for the TRACER 5045 system.
>TRACER S YSTEM C ONFIGURATION > M ODEM C ONTROL
Configures the modem control leads on the RS-232 port (terminal interface located on the rear panel of the
unit). Set
M ODEM C ONTROL
to E NABLED
when connecting the unit to a modem (using a null modem
adapter). Setting M ODEM C ONTROL
to D ISABLED
prevents the TRACER 5045 from monitoring DCD and
enables data to be sent to the VT100 continuously. M ODEM C ONTROL must be set to D ISABLED when the
VT100 terminal is in use. The TRACER 5045 comes factory programmed with M ODEM C ONTROL
set to
D ISABLED
.
>TRACER S YSTEM C ONFIGURATION > M ODEM C ONNECTION (L OGOUT )
Causes the TRACER 5045 to de-assert Clear To Send (CTS) and DSR for a time greater than 20 msec.
This signals the modem to disconnect the analog connection. Hangup-On-DTR-Drop may need to be
explicitly enabled on some modems. If
P ASSWORD P ROTECTION
is E NABLED
, this menu also causes the unit
to close the current session and return to the TRACER System Status menu page and wait for password
input.
>TRACER S YSTEM C ONFIGURATION > P ASSWORD E NABLE
Configures password protection for the VT100 terminal interface. Password protection for the
TRACER 5045 requires password input from the TRACER 5045 System Status menu page when
connecting to the unit. When configured for password protection, the TRACER 5045 closes any terminal
session that remains inactive for more than 10 minutes. The TRACER 5045 comes factory programmed
with
P ASSWORD E NABLE
set to D ISABLED
.
>TRACER S
YSTEM
C
ONFIGURATION
> P
ASSWORD
Sets the password for password protection of the TRACER 5045 VT100 terminal interface. Enter up to 8
alphanumeric characters. The system password is case sensitive.
>TRACER S YSTEM C ONFIGURATION > P ERFORMANCE S TATS (C LEAR )
Resets all system error counters for the TRACER 5045.
Press <Ctrl+Z> three times from the terminal interface to disable M ODEM C ONTROL
when
the modem control leads are active.
The default password for the TRACER 5045 is tracer.