Samsung SPH-M920ZKASPR - Manual (Page 34)

20 2A. Device Basics
Turning Your Device On and Off
Turning Your Device On
ᮣ Press and hold .
Once your device is on, it may display “Searching for
Service.” When your device finds a signal, it enters
standby mode – the device’s idle state. At this point,
you are ready to begin making and receiving calls.
If your device is unable to find a signal after 15 minutes
of searching, a Power Save feature is automatically
activated. When a signal is found, your device
automatically returns to standby mode.
In Power Save mode, your device searches for a signal
periodically without your intervention. You can also
initiate a search for Sprint service by pressing any key
(when your device is turned on).
Turning Your Device Off
1. Press and hold for two seconds until you
see the Phone options menu.
2. Tap ( Power off ) and then tap OK to power off
the device.
Your screen remains blank while your device is off
(unless the battery is charging).
Status Bar – Messaging Icons
Text Message – You have new text (SMS) or
multimedia (MMS) messages.
Voicemail Message – You have new voicemail
messages.
New Email message – Shows you have received
either a new Internet email message or Outlook
email message via an Exchange server.
New Gmail message – Shows you have received
a new Gmail message.
Tip: The Power Save feature conserves your battery power
when you are in an area where there is no signal.
SPH-M920.book Page 20 Friday, October 8, 2010 2:17 PM