Start-up, Connect equipment and power to the ups – American Power Conversion 5000VA User Manual
Page 12
8
Smart-UPS 5000 VA 208/230 Vac Tower/Rack-Mount 5U User Manual
Start-up
Connect Equipment and Power to the UPS
1. The UPS features a chassis ground connection screw located on the rear panel, for connecting the ground
leads on transient voltage devices.
Prior to connecting the grounding wire, ensure that the UPS is NOT connected to utility or battery
power.
2. Connect equipment to the UPS.
3. 208 V models: Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using
extension cords.
230 V models: Refer to the Input Hardwire section in this manual.
4. To use the UPS as a master on/off switch be sure all connected equipment is switched on.
Rear Panels
Start the UPS
1. Press the
button on the front panel to start the UPS.
–
The battery charges to 90% capacity during the first four hours of normal operation. Do not
expect full battery run capability during this initial charge period.
–
Refer to the APC Web site, www.apc.com for battery runtimes.
2. For optimal computer system security, install PowerChute Smart-UPS monitoring software.
208 V models
230 V models