Allied Telesis AT-SBx81CFC960 - Manual (Page 158)

Chapter 8: Installing the Transceivers and Cabling the Ports
158 Section II: Installing the Chassis
Note
To remove the connector and cable from the SFP+ slot, gently push
on the connector, pull on the release tab, and slide the connector
from the slot.
After installing the AT-SP10TW Cables, do one of the following:
 To install and cable additional transceivers, go to the appropriate
section in this chapter for instructions.
 After cabling all the ports in the chassis, go to Chapter 9,
“Powering On the Chassis” on page 171.