Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 158)

AlliedView™-EMS 4.0.3 Device Management Guide Page 158 of 468
•
Received DEs
•
Sent DEs
•
Logical Interface Index
•
Row Status
Note - The following parameters are implemented as 'read-only':
•
State
•
CIR
•
Maximum Line Speed
•
Throughput
Errors
Displays information about errors related to the Frame Relay module.
Note - The Faults and Fault Time parameters are not applicable to the AT-
AR700S series and should be ignored.
DS1
DS1 Config
Displays DS1 configuration.
Note - The current firmware version returns a 'noSuchName' value for the
Port Number parameter.
Note - The following parameters are implemented as 'read-only':
•
Line Type
•
Line Coding
•
Send Code
•
Circuit ID
•
Loopback Config
•
Signal Mode
•
Transmit Clock Source
•
Facilities Data Link
•
Line Length
•
Change Status Trap
•
Channelization
Near-End
Current 15-Min Interval Statistics
Displays near-end DS1 statistics every 15 minutes.
Statistics for Past 24 Hours
Displays near-end DS1 statistics for the past 24 hours.