Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 446)

AlliedView™-EMS 4.0.3 Device Management Guide Page 446 of 468
Note - The current firmware version is unable to display values for the following
parameters when the Management Module Chassis ID is set to 31:
•
Management Module Name
•
Management Module Type
•
Management Module 1.2V Status
•
Management Module 1.8V Status
•
Management Module 2.5V Status
•
Management Module 3.3V Status
•
Management Module 12.0V Status
•
Management Module Temperature
•
Management Module Software Version
•
Management Module Bootloader Version
•
Management Module Serial Number
•
Management Module Hardware Revision
Note - The current firmware version does not return valid values for the following
parameters when the Management Module Chassis ID is set to 31:
•
Module Location
•
Management Module Status
•
Management Module Present Status
•
Management Module Temperature Threshold
•
Reset Management Module
Module Info
Displays Module's information, including software and bootloader version of
linecards.
Note - The current firmware version will not return any information on the
status of the reset line card operation. As a result, Device Manager will not
display any indication that the reset line card operation was successful or
not.
Note - The Module Location parameter always displays the value '???(N)'.
Power and Fan Module Slot Info
Displays Power and Fan Module's information including the module's serial
number and status.
Network Info
Displays network-related information such as the addresses of the default gateway
and the TRAP Destination.