Allied Telesis AT-9448Ts/XP (Basic Layer 3) User Manual
At-9400ts stack installation guide
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Preface
- Chapter 1
- Overview
- Chapter 2
- Installing the Hardware
- Installation Overview
- Reviewing the Safety Precautions
- Planning the Installation of a Stack
- Maximum Number of Switches in a Stack
- Unpacking a Switch
- Installing the AT-StackXG Stacking Module
- Installing the Power Cord Retaining Clip (AC Switches Only)
- Disconnecting the Network Cables
- Installing the Switches in an Equipment Rack
- Labeling the Switches
- Chapter 3
- Preparing the Switches
- Chapter 4
- Cabling and Powering on the Stack
- Chapter 5
- Cabling the Network Ports
- Chapter 6
- Adding and Removing Switches
- Chapter 7
- Troubleshooting
- No Master Switch
- Power LED is Off
- Twisted Pair Port Link LED is Off
- Fiber Optic Port Link LED is Off
- Transceiver is Installed but the Status is “Not Present”
- System Fault LED is Blinking
- System Fault LED is Steadily On
- Cannot Establish a Local (Out-of-Band) Management Session
- Switch Functions Intermittently
- Appendix A
- Technical Specifications