Allied Telesis AT-9448Ts/XP (Basic Layer 3) - Manual (Page 42)

Chapter 2: Installing the Hardware
42
Installing the Power Cord Retaining Clip (AC Switches Only)
Perform the following procedure to install the power cord retaining clip on
the switches:
1. Locate the power cord retaining clip, shown in Figure 12.
Figure 12. Power Cord Retaining Clip
2. Install the clip on the AC power connector on the back panel of the
switch. With the “u” of the clip facing down, press the sides of the clip
toward the center and insert the short ends into the holes in the
retaining bracket, as shown in Figure 13.
Figure 13. Inserting the Retaining Clip into the Retaining Bracket
If the switches of the stack were used as stand-alone units in your
network, go to the next procedure to remove the network cables.
Otherwise, go to “Installing the Switches in an Equipment Rack” on
page 44.
100-240V
AC ~
100-240V
AC ~