Allied Telesis AT-9448Ts/XP (Basic Layer 3) - Manual (Page 47)

47
Chapter 3
Preparing the Switches
The chapter contains the following procedures:
ˆ “Powering on a Switch” on page 48
ˆ “Starting a Local Management Session” on page 50
ˆ “Verifying the AT-S63 Version Number” on page 52
ˆ “Updating the AT-S63 Management Software” on page 53
ˆ “Assigning the Static Module ID Number 1 to the Master Switch” on
page 54
ˆ “Assigning Static Module ID Numbers to the Member Switches” on
page 57
Note
The cables should not be connected to the AT-StackXG Modules
during the procedures in this chapter.