Allied Telesis AT-S62 - Manual (Page 191)

AT-S62 Menus Interface User’s Guide
Section II: Advanced Operations 191
8. Enter a name for the file. The file is given this name when stored in the
switch’s file system. When naming a file, be sure to give it an
extension that corresponds to its file type. The extensions and file
types are listed in Table 2 on page 190.
The following prompt is displayed:
You are going to invoke the Xmodem download utility.
Do you wish to continue? [Yes/No]
Note: Please select 1K Xmodem protocol for faster
download.
9. Type Y for Yes.
The prompt “Downloading” is displayed.
10. Begin the file transfer of the system file.
Note
The transfer protocol must be Xmodem or 1K Xmodem.
Steps 11 through 14 illustrate how to download a file with the
Hilgraeve HyperTerminal program.
11. From the HyperTerminal main window, select Send File from the
Transfer pull-down menu, as shown in Figure 52.
Figure 55 Local Management Window
The Send File window is shown in Figure 53.
Figure 56 Send File Window