Allied Telesis AT-S62 - Manual (Page 398)

Chapter 22: SNMPv3 Configuration
Section III: SNMPv3 Operations 398
The following prompt is displayed:
Do you want to delete this table entry? (Y/N):
[Yes/No]->
6. Enter Y to delete this SecurityToGroup entry or N to save it.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3
SecurityToGroup
Table Entr y
This section describes how to modify parameters in an SNMPv3
SecurityToGroup Table entry. See the following procedures:
❑ Modifying the Group Name on page 398
❑ Modifying the Storage Type on page 400
Modifying the Group Name
To modify the Group Name in an SNMPv3 SecurityToGroup Table entry,
perform the following procedure.
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 360. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 127 on
page 361.
2. From the Configure SNMPv3 Table Menu, type 5 to select Configure
SNMPv3 SecurityToGroup Table.
The Configure SNMPv3 SecurityToGroup Table is shown in Figure
132 on page 380.
3. From the Configure SNMPv3 SecurityToGroup Table, type 3 to select
Modify SNMPv3 Table Entry.