Allied Telesis AT-S62 - Manual (Page 63)

AT-S62 User’s Guide
Section I: Basic Operations 63
The following prompt is displayed:
BOOTP/DHCP (E-Enabled, D-Disabled):
4. Type E to enable BOOTP and DHCP services on the switch or D to
disable the services and press Return. The default is disabled.
Note
If you activate the BOOTP/DHCP client software, the switch
immediately begins to query the network for a BOOTP or DHCP
server. The switch continues to query the network for its IP
configuration until it receives a response.
Any static IP address, subnet mask, or gateway address assigned to
the switch is deleted from the System Configuration menu and
replaced with the value the switch receives from the BOOTP or
DHCP server. If you later disable BOOTP and DHCP, these values are
returned to their default settings.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.