Allied Telesis AT-S62 - Manual (Page 701)

AT-S62 User’s Guide
Section VIII: Web Browser Management 701
Modifying an
Access Table
Entry
To modify an entry in the SNMPv3 Access Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Access Table. Then click Configure at the bottom of the page.
The SNMPv3 Access Table Page is shown in Figure 239 on page
697.
4. Display the Access Table entry that you want to change.
Click Next or Previous to display an entry.
5. Click Modify.
The Modify SNMPv3 Access Page is shown in Figure 241.
Figure 241 Modify SNMPv3 Access Page
Note
The Context Prefix field is a read-only field. The Context Prefix field
is always set to null.
6. In the Read View Name field, enter a value that you configured with
the View Name parameter in the View Table.