Allied Telesis AT-VIEW PLUS 3.0 INSTALLATION - Manual (Page 18)

Allied Telesyn AT-VIEW PLUS 3.0
INSTALLATION GUIDE
8 INTEGRATING AT-VIEW PLUS 3.0 WITH NETVIEW
The AT-View Plus 3.0 installer automatically detects if NetView is installed and will perform the
necessary integration so that AT-View Plus 3.0 can be started from within NetView. After integration,
the “AT-View Plus” submenu is added to the “Tools” menu. “AT-View Plus” contains the options “Device
Manager” and “AMIGO”.
After installing AT-View Plus 3.0, NetView does not immediately update its maps to show Allied Telesyn
icons. You can use the “Demand Poll” selection from the “Test” menu to force NetView to refresh its
maps or wait for NetView to complete its scheduled “Polling for Node Configuration”. You can also
change the default period of the “Polling for Node Configuration” in order for the discover node
configuration to take effect immediately.
To start AT-View Plus for an Allied Telesyn device, follow the steps below:
1. Select an Allied Telesyn device on the network map.
2. Select Tools>AT-View Plus>Device Manager or AMIGO.
3. Device Manager or AMIGO will be launched.
PN 613-50659-00 Rev A Page 18 of 26