Allied Telesis AT-VIEW PLUS 3.0 INSTALLATION - Manual (Page 4)

Allied Telesyn AT-VIEW PLUS 3.0
INSTALLATION GUIDE
1 INTRODUCTION
This Installation Guide describes the installation, configuration, and registration procedures for AT-View
Plus 3.0 on Windows and UNIX. It also describes the system requirements for the application. AT-View
Plus includes the AT-View Plus application for managing Allied Telesyn devices, the MIB browser Amigo,
the MIB Compiler and VLAN Manager.
2 SYSTEM REQUIREMENTS
The following software and hardware components are required to run AT-View Plus 3.0. Make sure that
your system meets these requirements before installing AT-View Plus 3.0.
2.1 Windows
Hardware Pentium based PC, 64MB RAM (128MB+ recommended)
CPU Pentium 166MHz or greater (400MHz+ recommended)
Operating System 32-bit Windows: Windows NT 4.0 (SP6a or later), Windows 2000 (SP3
or later), Windows XP (SP1 or later), Windows 2003
Video 1024 x 768 pixels, 64K or more colors
Supported NMS HP OpenView Network Node Manager v6.20 and v7.0; SNMPc 5.1.6c,
6.0 and 7.0; Tivoli NetView 7.1.3
Hard Disk Space 80MB or greater (160MB or greater HDD space is temporarily required
during installation)
2.2 Solaris
Hardware SPARC station 20 or UltraSparc series (UltraSparc recommended),
128MB RAM (256MB recommended)
Operating System Sun OS 5.8/Solaris 8 (32-bit version)
Video
64K or more colors
Supported NMS HP OpenView Network Node Manager v6.20 and v7.0
Hard Disk Space 95MB or greater (at least 15MB of SWAP area is required during
start-up; 190MB HDD space is temporarily required during installation)
2.3 HP-UX
Hardware HP 9000 Workstations, HP Visualize Workstations, 128 MB RAM (256
recommended)
Operating System HP-UX 11 (32-bit version)
Video
64K or more colors
Supported NMS HP OpenView Network Node Manager v6.20 and v7.0
Hard Disk Space 190MB or greater (at least 15MB of SWAP area is required during
start-up; 380MB HDD space is temporarily required during installation)
PN 613-50659-00 Rev A Page 4 of 26