Allied Telesis AT-VIEW PLUS 3.0 INSTALLATION - Manual (Page 7)

Allied Telesyn AT-VIEW PLUS 3.0
INSTALLATION GUIDE
If you plan to integrate AT-View Plus 3.0 with SNMPc or OpenView, select No and click
Next to continue. Selecting No will terminate the installation setup program. You then
need to stop SNMPc or OpenView services and start the installer again.
If you do not plan to integrate AT-View Plus 3.0 with SNMPc or OpenView, select Yes
and click Next to continue. The installer will then proceed to the next window.
Note that the opposite applies for NetView. The window will be displayed if NetView
services are not running.
4. Specify whether you want to install both the AT-View Plus 3.0 application and its
documentation. You also have the option to install either the application or the
documentation only.
Click Next to continue.
If you choose to install the AT-View Plus 3.0 application only, the documentation for the
application will not be available after the installation. You will have to run the installer
again and choose the option “AT-View Plus Documentation” to install the
documentation.
If you choose to install the AT-View Plus 3.0 documentation only, you will have to
specify a folder where the documents will be installed, unless AT-View Plus 3.0
application is already installed. You will not have the option to integrate AT-View Plus
3.0 with SNMPc, OpenView, or NetView since you will not be installing the application.
PN 613-50659-00 Rev A Page 7 of 26