Allied Telesis AT-VIEW PLUS 3.0 INSTALLATION - Manual (Page 5)

Allied Telesyn AT-VIEW PLUS 3.0
INSTALLATION GUIDE
3 BEFORE YOU BEGIN
Make sure that you satisfy the following requirements before installing AT-View Plus 3.0.
• You must have administrative rights on the machine where you will install AT-View Plus 3.0. To
make sure that you have administrative rights, log on as administrator before installing AT-View
Plus 3.0.
• If you plan to integrate AT-View Plus 3.0 with Castle Rock SNMPc or HP OpenView, you have to
install SNMPc or OpenView first before installing AT-View Plus 3.0. Before installing AT-View Plus
3.0, stop SNMPc or OpenView if it is running.
• If you plan to integrate AT-View Plus 3.0 with Tivoli NetView, you have to install NetView first before
installing AT-View Plus 3.0. Before installing AT-View Plus 3.0, ensure that NetView is running.
• Please refer to Section 11 Installation/Uninstallation Notes for any known installation-related issues.
4 INSTALLING AT-VIEW PLUS 3.0
4.1 WINDOWS
To install AT-View Plus 3.0 for Windows, perform the following procedure.
1.
Close all Windows applications before installing AT-View Plus 3.0 so that the application
can detect any existing network management system (NMS) installation in the shortest
possible time.
2. Insert the AT-View Plus 3.0 Installation CD in the CD drive. The AT-View Plus 3.0
installation setup program will automatically execute and the AT-View Plus 3.0 splash
screen is displayed for a few seconds.
If you downloaded the AT-View Plus installer from the Allied Telesyn FTP site, point to
the folder where the installer program was copied to and double click ATVP300.exe.
3. The Welcome window appears after the splash screen has been displayed.
PN 613-50659-00 Rev A Page 5 of 26