Spektrum SPMAR635 - Manual (Page 12)

EN
12
Adjusting the Gain Values
IMPORTANT: Aileron and Elevator Reversing MUST be set to Normal
to access the programming menus. During gain adjustment, the Throttle
channel is inactive. Power is still supplied to the Aileron, Elevator and Rudder
servos.
WARNING: ALWAYS remove the propeller before programming the
receiver. If you have not removed the propeller yet, STOP. Power off
the aircraft and remove the propeller before continuing with the
receiver programming.
To enter the Gain Control Menu:
1. Power on your transmitter.
2. Move the throttle stick to the middle (1/2 throttle) position.
3. Hold full Right Aileron and full Up Elevator while powering on the receiver
(as shown in Figure 4). After 5 seconds, the Green, Red and Blue LEDs in
the receiver flash, indicating the channel, gain value and sensor direction.
4. The Throttle MUST remain at the middle position during programming.
Release the Aileron and Elevator sticks, leaving the Throttle in the middle
position.
(Figure 4)
Entering Gain Control by Stick Combination:
Aileron/Elevator Reversing
Mode 1
Aileron Elevator
Normal Normal
Mode 2
“Sample Aircraft Gain Settings” are located at the back of this manual.