Spektrum SPMAR635 - Manual (Page 9)

EN
9
Selecting the Transmitter Type
IMPORTANT: Aileron and Elevator Reversing MUST be set to Normal to access
the programming menus.
Before programming the AR635 receiver, you must program the receiver for the
transmitter type you want to use:
• Sport Aircraft, All Transmitters
• 3D Aircraft, Computer Transmitter
• 3D Aircraft, Non-Computer Transmitter
WARNING: ALWAYS remove the propeller before programming the
receiver. Each time you save a selection, the receiver will exit the
programming menu and activate the ESC.
Sport Aircraft
1. Power on your transmitter.
2. Move the throttle stick to the middle (1/2 throttle) position.
3. Hold full Left Aileron and full Up Elevator while powering on the receiver
(as shown in Figure 1). After 5 seconds, the Green, Red and Blue LEDs in
the receiver turn solid, then begin flashing.
4. Release the transmitter sticks.
5. Center both sticks, then move the throttle to the off position to save the
selection. The ESC will regain control.
(Figure 1)
Entering Transmitter Type by Stick Combination:
All Transmitters: Sport
Mode 1
IMPORTANT: Aileron and
Elevator Reversing must be
set to Normal/Normal during
receiver programming and gain
adjustment.
Mode 2