Spektrum SPMAR635 - Manual (Page 8)

EN
8
Receiver Installation
You can install the receiver under the canopy or in the bottom of the fuselage,
as long as the servo pins point toward the nose or tail of the aircraft.
IMPORTANT: The AR635 receiver does not support dual servo mixing (dual
elevator, dual rudder, elevon or flaperon). If your aircraft requires dual elevator,
rudder or aileron servos, you will need to use a Y-harness.
Attention: For optimum RF link performance, position the antennas so they
are perpendicular to each other. Doing so provides the best signal reception in
flight.
1. Locate a flat spot inside the fuselage where you can install the receiver.
The spot must be large enough to make contact with the entire base of
the receiver case. Add or remove material in the fuselage as necessary.
2. Apply high-quality, double-sided foam tape to the receiver case and press
the receiver case against the radio tray. The receiver must be mounted
securely to prevent it from moving in flight.
3. Connect the servos to the receiver.
ONLY install the receiver into your aircraft in the following orientations.