Spektrum SPMAR635 - Manual (Page 7)

EN
7
Binding the Transmitter and Receiver
You must bind the receiver to the transmitter before the receiver will operate.
Binding is the process of programming the receiver to recognize the GUID
(Globally Unique Identifier) code of a single specific transmitter. To bind the
AR635 receiver to a DSM2 or DSMX transmitter:
1. Insert the bind plug in the BIND port on the receiver.
2. Power on the receiver. The receiver can be powered through any open
port. The orange bind LED on the receiver flashes rapidly to indicate the
receiver is in bind mode.
Attention: To bind the receiver using an electronic speed control (ESC),
insert the bind plug into the BIND port in the receiver and the ESC lead into
the throttle (THRO) port.
3. Keep the plane motionless for 5 seconds.
4. Move the throttle stick to the low throttle position.
5. Put your transmitter in Bind Mode. The system connects within a few
seconds. Once connected, the orange LED light turns solid and the
AR635 receiver begins the calibration process (Green, Blue and Red LED
lights flash).
6. Remove the bind plug from the BIND port on the receiver before you
power off the receiver and transmitter.
7. Set up your model, then rebind the system so the true low throttle position
is set in the failsafe. Store the bind plug in a convenient place.
CAUTION: Always remove the bind plug to prevent the system from
entering bind mode the next time you power on the receiver. Failure
to complete this step could result in the aircraft crashing or personal injury.