Installing and charging the battery pack – Nikon Coolwalker User Manual
Page 18
8
Pr
ep
ar
at
io
n
—
In
sta
llin
g
a
n
d
C
h
ar
g
in
g
th
e B
at
te
ry
P
ac
k
Installing and Charging the Battery Pack
Before Using the COOLWALKER MSV-01 Remove the Insulating Tape.
The battery pack is shipped with an insulating tape
over its terminal.
(1) Remove the battery pack from the MSV-01 main
unit following the instructions provided in the
"Removing the Battery Pack" section below.
(2) Remove the insulating tape from the battery pack.
(3) Reinstall the battery pack following the instruc-
tions provided in the "Installing the Battery Pack"
section below.
1
Removing the Battery Pack
Push the battery release button (
➀
) and slide the bat-
tery pack in the direction of the arrow (
➁
) to remove
it from the the MSV-01 main unit (
➂
).
2
Installing the Battery Pack
(1) Align the battery pack horizontally with the bot-
tom of the MSV-01 main unit as shown on the
illustration (
➃
). Make sure that the battery pack
terminals do not extend over the main unit pro-
truding part (
➄
).
(2) Slide the battery pack in the direction of the
arrow onto the bottom of the MSV-01 main unit
until it locks into position (
➅
). Make sure that the
battery pack is fully seated as shown on the illus-
tration (
➆
,
➇
).
3
Charging the Battery Pack
To charge the battery pack, it must first be installed
on the MSV-01 main unit.
(1) Make sure that the power-on lamp on the MSV-01
main unit is off.
Insulating
tape
Terminals
➂
➁
➀
➃
➄
➄
➆
➅
➇
Power-on lamp