Nikon Coolwalker - Manual (Page 22)

12
B
as
ic
O
p
er
at
io
n
—
In
se
rti
n
g
a
M
em
o
ry
C
ar
d
Basic Operation
Inserting a Memory Card
To copy image data from a memory card to the MSV-01 or from the MSV-01 to a memory card,
insert a CompactFlash™ memory card into the memory card slot.
Removing Memory Cards
Memory cards can be removed without loss of data when the MSV-01 is off. To remove a memory card,
turn the MSV-01 off and confirm that the power-on lamp is off or, if the AC adapter is connected, is lit or
flashing orange. Then grasp the protruding section of the memory card, and pull it out.
Note that memory cards may become hot during use. Observe due caution when removing memory
cards from the MSV-01.
Supported Memory Cards
The memory card slot accepts CompactFlash™ memory cards (Type I and II).
On memory cards approved for use with the COOLWALKER MSV-01 see "Approved Memory Cards"
(
57).
1
Turn the MSV-01 off
Confirm that the monitor is off and the power-on lamp is off
or, if the AC adapter is connected, is lit or flashing orange
(
10).
2
Open the memory card slot cover
Gently slide the memory card slot cover downwards to expose
the memory card slot.
3
Insert a memory card
Insert a memory card into the memory card slot in the direc-
tion shown on the illustration.
Insert the memory card firmly, but without excess force.
(When correctly inserted, a CompactFlash™ memory card
protrudes approximately 12 mm from the MSV-01 main unit.)
Inserting Memory Cards
• Insert the memory card terminals first. Inserting the card
upside down or backwards could damage the MSV-01 or the
card. Check to be sure that the card is in the correct orienta-
tion.
• Perform all operations on a table or any other stable flat sur-
face to avoid dropping the MSV-01 or memory cards.
Front
Terminals
Direction of
insertion
12mm