Nikon Coolwalker - Manual (Page 71)

61
Te
ch
n
ic
al
N
o
te
s—
C
ar
in
g
fo
r Y
o
u
r C
O
O
LW
A
LK
ER
M
SV
-0
1
Cleaning
Body
Use a blower to remove dust and lint, then
wipe gently with a soft, dry cloth.
After using your MSV-01 at the beach or sea-
side, wipe off any sand or salt with a cloth
lightly dampened with fresh water, then dry
thoroughly.
LCD Monitor
Remove dust or lint with a blower. To remove
fingerprints and other stains, clean the monitor
with a soft, dry cloth, being careful not to
apply excessive pressure.
Avoid contact with liquid crystal
Should the monitor break, care should be
taken to avoid injury due to broken glass
and to prevent the liquid crystal from the
monitor touching the skin or entering the
eyes or mouth.
Notes on the LCD Monitor
• The monitor may contain a few pixels that are
always lit or that do not light. This is a charac-
teristic common to all TFT LCD displays, and
does not indicate a malfunction.
• Images in the monitor may be difficult to see
in a bright light.
• The monitor is lit by an LED backlight. Should
the monitor begin to dim or flicker, contact
your Nikon service representative.
Storage
Turn the MSV-01 off and remove the AC
adapter when not in use.
Be sure to close the memory card slot and inter-
face connector covers and keep the MSV-01
main unit in the provided soft case.
Do not store the products in locations that:
• are poorly ventilated or damp
• are next to equipment that produces
strong electromagnetic fields, such as tele-
visions or radios
• are exposed to static electricity
• are exposed to vibrations
• are exposed to excessive moisture or
humidity
• are exposed to risk of short circuits
• are exposed to excessive dust
• are exposed to temperatures below -10°C
(14°F) or above 45°C (113°F)
• are subject to humidities of over 60%
To prevent deterioration of battery pack
performance, it is recommended that the product
be stored in dry locations with an ambient
temperature of 15 - 25°C (59-77°F).
When storing the MSV-01 for long periods, charge
the battery pack and remove the battery from the
remote control unit before putting it away.
Do not use alcohol, thinner, or other
volatile chemicals.