Nikon S7c - Manual (Page 185)

171
Te
ch
n
ica
l No
te
s
Troubleshooting
If the camera fails to function as expected, check the list of common prob-
lems below before consulting your retailer or Nikon representative. Refer to
the page numbers in the right-most column for more information.
Display, Settings and Power Supply
Problem Cause/Solution c
Monitor is blank • Camera is off.
• Battery is exhausted.
• Standby mode for saving power: press
the shutter-release button halfway.
• Flash lamp blinks red: wait until flash
has charged.
• USB cable is connected.
• A/V cable is connected.
• Time lapse or interval timer photogra-
phy in progress.
24
24
25, 28
33
83
82
Monitor is hard to read • Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
• Monitor has dimmed to save power.
Monitor brightens when controls are
used.
120
164
25
Camera turns off without warn-
ing
• Battery is low.
• Camera has turned off automatically
to save power.
• Battery is cold.
24
163
[Format memory] > [Format]
option not available
Battery is low. 24,
125
Camera clock is not correct • Clock battery exhausted: recharge
clock battery. Pictures recorded before
clock has been set will have time
stamp of “00.00.0000 00:00”; movies
will be dated “01.09.2006 00:00.”
• Check camera clock regularly against
more accurate timepieces and reset as
required.
20
117
No indicators displayed in moni-
tor
[Hide info] is selected for [Photo info].
Select [Show info].
120
[Date imprint] not available Camera clock has not been set. 20,
117