A.J. Antunes & Co VCT-2000 9210410 - Manual (Page 10)

VERTICAL CONTACT TOASTER
10 P/N 1010840 Rev. M 07/14
Safety Features
HI-LIMIT RESET BUTTON
A Hi-Limit Control turns off electrical power to the heat-
er and control circuits if the platen overheats. To reset
the control, allow sufficient time (10-15 minutes) for the
unit to cool, then locate the Reset Button at the rear
of the unit. Remove the black protective cap, press
the Reset Button, and reinstall the protective cap
(Figure 2).
NOTE: If the unit requires continuous resetting,
contact your Authorized Service Agency.
TEMP
UP
TEMP
DOWN
TEMP
SCALE
°F
°C
POWER
551
Figure 5. Platen Heater Set Point Temperature
1. Press both buttons at the same
time for 1 second to start adjust-
ment sequence.
2. Press TEMP UP button to raise
platen set point temperature.
3. Press TEMP DOWN button
to lower platen set point
temperature.
TEMP
UP
TEMP
DOWN
TEMP
SCALE
°F
°C
POWER
336
Figure 6. Auxiliary Air Heaters Set Point Temperature
1. Press both buttons at the same
time for 1 second to start adjust-
ment sequence.
2. Press TEMP UP button to raise
auxiliary air heaters set point
temperature.
3. Press TEMP DOWN button to
lower auxiliary air heaters
set point temperature.
OPERATION (continued)