A.J. Antunes & Co VCT-2000 9210410 - Manual (Page 15)

15
VERTICAL CONTACT TOASTER
P/N 1010840 Rev. M 07/14
Weld
Screws
Acorn Nuts
Spacers
Tensioner
Assy.
Tape
Figure 16. Replacing Roller Tensioner Assy.
Figure 15. Measuring Roller Tensioner
REPLACING ROLLER TENSIONERS
1. Remove the acorn nuts and old Roller Tensioner
assembly (Figure 15).
2. Replace Roller Tensioner assembly, and reas-
semble.
3. Make sure the spacers are placed inside the
tensioner arm. The spacers are smaller than the
holes to allow the tensioner to pivot freely.
MAINTENANCE (continued)
Roller Tensioners (Every 3–6 months)
MEASURING ROLLER TENSIONERS
1. Measure the Roller Tensioner on both inner
Conveyor Covers (See illustration). Adjust or
replace any damaged ones as recommended.
The space between the inner Conveyor Cover
and bottom of the tensioner wheel should be
13/16” (2.1 cm) or the height of a U.S. Nickel.