22 using the eat disable setting, 23 using the intm film print cooling level setting, 26 using the holo transfer offset setting – HID HDPii Plus User Guide 2.0 User Manual

Page 33: 27 using the standby temp setting, 28 using the mag hi-co voltage offset setting, 29 using the mag lo-co voltage offset setting, 30 using the mag flipper angle offset setting, 31 using the lamination top of form setting, 32 using the lamination end of form setting, 33 using the lamination bottom takeup setting

Advertising
22 using the eat disable setting, 23 using the intm film print cooling level setting, 26 using the holo transfer offset setting | 27 using the standby temp setting, 28 using the mag hi-co voltage offset setting, 29 using the mag lo-co voltage offset setting, 30 using the mag flipper angle offset setting, 31 using the lamination top of form setting, 32 using the lamination end of form setting, 33 using the lamination bottom takeup setting | HID HDPii Plus User Guide 2.0 User Manual | Page 33 / 103 22 using the eat disable setting, 23 using the intm film print cooling level setting, 26 using the holo transfer offset setting | 27 using the standby temp setting, 28 using the mag hi-co voltage offset setting, 29 using the mag lo-co voltage offset setting, 30 using the mag flipper angle offset setting, 31 using the lamination top of form setting, 32 using the lamination end of form setting, 33 using the lamination bottom takeup setting | HID HDPii Plus User Guide 2.0 User Manual | Page 33 / 103
Advertising
See also other documents in the category HID Equipment: